Fence layout planner

Posts on a run = its length ÷ the post spacing, rounded up, plus one, with corners and gates shared between runs: a straight 48 ft run with posts up to 8 ft apart takes 7 posts.

Your measurements

Example

Use the unit shown for each box, or type another one: 12 ft 6 in, 150 in, 3.8 m and 600 mm all work, as do the marks on a tape measure.

Fence section 1

Example: replace these measurements

Your material list

7 posts on the plan

48 ft measured run

Your measured layout
1: 48 ftNorth ↑ · East → · dashed lines are gates
Top view of every run, numbered in the order you entered them. Slopes are not drawn. A separate run starts from the same corner of the drawing as the first one; if two runs should meet, choose “corner” or “straight continuation”.

Your shopping list

  • 7 posts on the plan
Quantities and package details
end posts
2
corner posts
0
gate posts
0
grade posts
0
line posts
5
Fence section
(0, 0) to (48, 0) ft

The calculation

  1. Fence section: Δx = 48 × cos(0°); Δy = length × sin(direction).

Common questions

How do I draw a fence plan?

Enter each straight run with its length and direction in degrees, east being zero and north 90. A connected run starts where the previous one ended. Check the drawing and the coordinate list against your survey.

Does the planner find my property line?

No. A drawn line is not a survey. Confirm the boundary and arrange utility locating before anyone digs.

How to plan the quantity

The first section begins at an arbitrary origin. Enter direction in degrees: east is zero and north is 90. A connected section starts at the previous endpoint; a separate section resets to the origin.

Gate positions are horizontal distances from the start of each run. The post calculation uses the actual slope length but the drawing is a horizontal plan.

Compare the drawing with your survey or site plan. It does not find your property boundary.

Before you order

  • Closing the drawn outline does not prove boundary accuracy, utility clearance or permit compliance.
  • A repeated start and end location is not automatically merged: identify the final shared terminal with your supplier before ordering.

Your project

My project

Saved in this browser only. Choose “Save in this browser” in any calculator or worksheet to add it here.

Choose a calculator